What to do if my Juniper SRX320 Gateway is not receiving power?
First, check the AC power cord connecting the power source to the device for any damage, and replace it immediately if the insulation is cracked or broken. Next, make sure the power socket you are using is working correctly. Also, verify that the device is receiving an AC input voltage between 100 and 240 VAC.
What to do if my Juniper Gateway boots from an alternate boot device?
If the internal flash memory fails at startup, the Juniper Gateway automatically boots from the alternative boot device (USB storage device). If this is not the intended boot device, reformat the internal flash memory and install a bootable image. If you did not configure the services gateway to boot from an alternative boot device, contact JTAC.
General| Firewall throughput | 1000 Mbit/s |
|---|---|
| Number of users | 50 user(s) |
| Quality of Service (QoS) support | Yes |
| Mobile VPN IPSec | 250 |
| IPS/IDS throughput | 100 Mbit/s |
| USB 2.0 ports quantity | 1 |
| Connectivity technology | Wired |
| SFP module slots quantity | 2 |
| Ethernet LAN (RJ-45) ports | 6 |
| Internal memory | 4000 MB |
| Flash memory | 8000 MB |
| Storage media type | Flash |
| Power consumption (typical) | 27 W |
| Heat dissipation | 157 BTU/h |
| Concurrent connections | 64000 |
| Mean time between failures (MTBF) | 284700 h |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Storage relative humidity (H-H) | 5 - 95 % |
| Operating relative humidity (H-H) | 10 - 90 % |
| Routing protocols | BGP, CLNS, IS-IS, OSPF, RIP-1, RIP-2 |
Weight and Dimensions| Weight | 1510 g |
|---|---|
| Dimensions (WxDxH) | 299.9 x 43.9 x 191 mm |
To Next Page
