Juniper SRX320 - Chapter 28 Electrical Safety Guidelines and Warnings

CHAPTER 28
Electrical Safety Guidelines and Warnings
•
In Case of Electrical Accident on page 129
•
General Electrical Safety Guidelines and Warnings on page 129
In Case of Electrical Accident
If an electrical accident results in an injury, take the following actions in this order:
1. Use caution. Be aware of potentially hazardous conditions that could cause further
injury.
2. Disconnect power from the services gateway.
3. If possible, send another person to get medical aid. Otherwise, assess the condition
of the victim, then call for help.
Related
Documentation
General Electrical Safety Guidelines and Warnings on page 129•
General Electrical Safety Guidelines and Warnings
•
Install the services gateway in compliance with the following local, national, or
international electrical codes:
•
United States—National Fire Protection Association (NFPA 70), United States
National Electrical Code
•
Canada—Canadian Electrical Code, Part 1, CSA C22.1
•
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7
•
Evaluated to the TN power system
•
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
•
Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
•
Never assume that power is disconnected from a circuit. Always check the circuit before
starting to work.
129Copyright © 2016, Juniper Networks, Inc.