admin@device# commit
19. When you have finished configuring the services gateway, exit configuration mode.
[edit]
admin@device# exit
admin@device>
Related
Documentation
Configuring the SRX320 Services Gateway Using the J-Web Setup Wizard on page 75•
Verifying Settings for the SRX320 Services Gateway
Access http://www.juniper.net to verify connectivity. If the page does not load, perform
the following checks to see if you can identify the problem:
•
Check if the cable connecting the ISP-supplied device to the SRX Series device is firmly
seated.
•
Use the CLI ping command to verify that the services gateway can be accessed from
the management device.
•
Check if the management device has an IP address in the 192.168.1.0/24 subnetwork.
•
Clear the browser cache on the management device.
After you complete these steps, the device can pass traffic from any trust port to the
untrust port. You can connect other devices to the SRX Series device.
Related
Documentation
• Configuring the SRX320 Services Gateway Using the CLI on page 79
• Configuring the SRX320 Services Gateway Using the J-Web Setup Wizard on page 75
81Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Performing the Initial Configuration
To Next Page
Loading...
