CHAPTER 12
Unpacking the SRX320 Services Gateway
•
Required Tools and Parts for Unpacking the SRX320 Services Gateway on page 45
•
Unpacking the SRX320 Services Gateway on page 45
•
Verifying Parts Received with the SRX320 Services Gateway on page 46
Required Tools and Parts for Unpacking the SRX320 Services Gateway
To unpack the SRX320 Services Gateway, you need the following tools:
•
Phillips (+) screwdriver, number 2
•
Blank panels to cover any slots not occupied by a component
Related
Documentation
Unpacking the SRX320 Services Gateway on page 45•
• Verifying Parts Received with the SRX320 Services Gateway on page 46
Unpacking the SRX320 Services Gateway
The SRX320 Services Gateway is shipped in a cardboard carton and secured with foam
packing material. The carton also contains an accessory box and quick-start instructions.
To unpack the SRX320 Services Gateway:
1. Move the cardboard carton to a staging area as close to the installation site as possible,
where you have enough room to remove the components from the chassis.
2. Position the cardboard carton with the arrows pointing up.
3. Carefully open the top of the cardboard carton.
4. Remove the foam covering the top of the services gateway.
5. Remove the accessory box.
6. Verify the parts received against the lists in “Verifying Parts Received with the SRX320
Services Gateway” on page 46.
7. Store the brackets and bolts inside the accessory box.
8. Save the shipping carton and packing materials in case you need to move or ship the
services gateway at a later time.
45Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
