Configurations you can perform with the setup wizard include:
•
Configuring basic options such as device name, root password, and system time
•
Configuring the security topology
•
Internet zone
•
Internal zones
•
DMZ
•
Defining security policies and Network Address Translation (NAT) rules
•
Configuring remote access
NOTE: Before applying the configuration changes to the services gateway,
check the connectivity to the services gateway. You might lose connectivity
if you have changed the management zone IP. Click the URL for reconnection
instructions for information on how to reconnect to the device.
After you finish configuring the services gateway with the setup wizard and commit your
configuration, you are redirected to the J-Web interface. Thereafter, whenever you connect
to the services gateway, you are placed in the J-Web interface. You can access the setup
wizard from the J-Web interface and use it to reconfigure your services gateway. To do
so, select Configuration Wizards>Set Up. You can either edit an existing configuration or
create a new configuration.
NOTE: If you elect to create a new configuration, then all the current
configuration in the services gateway will be deleted.
Related
Documentation
Configuring the SRX320 Services Gateway Using the CLI on page 79•
Accessing the CLI on the SRX320 Services Gateway
To access the CLI on the SRX320 Services Gateway:
1. Plug one end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter supplied
with your services gateway.
2. Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management
device.
3. Connect the other end of the Ethernet cable to the serial console port on the services
gateway. See Figure 18 on page 78.
77Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Performing the Initial Configuration
To Next Page
Loading...
