CHAPTER 17
Providing Power to the SRX320 Services
Gateway
•
Connecting the SRX320 Services Gateway to the Power Supply on page 67
•
Powering On the SRX320 Services Gateway on page 68
•
Powering Off the SRX320 Services Gateway on page 68
Connecting the SRX320 Services Gateway to the Power Supply
To connect the device to the power supply:
CAUTION: Before connecting the device to the power supply, attach an ESD
strap to an ESD point and place the other end of the strap around your bare
wrist.
1. Plug the DC connector end of the power cable into the power connector on the back
of the device as shown in Figure 16 on page 67.
2. Plug the AC adapter end of the power cable into an AC power outlet.
Figure 16: Connecting the SRX320 Services Gateway to the Power Supply
Related
Documentation
Understanding the SRX320 Services Gateway Power Supply on page 15•
• SRX320 Services Gateway Power Specifications and Requirements on page 34
67Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
