Hangzhou Junce Instruments Co., Ltd.
Function Instruction
Load the parameters of a certain location of 9
storage locations (M1-M9).
Save the parameters to one of 9 storage
locations of M1to M9.
Working hours and ampere hours are cleared.
Address (a total of 99 addresses from 01 to 99),
different addresses represent different host
power supply, and it can control one-to-many
display.
Channels (a total of 30 addresses from 01 to
30), different addresses represent different host
power supply, and it can control one-to-many
display. Setting the host address to 00 means
that it is not controlled by any wireless
controller.
After the rapid discharge is turned on, the
response time when the voltage changes from
high to low is relatively short.
After the automatic output is turned on, the
output will be automatically turned on when the
power is turned on.
ON (Turn on), OFF (Turn off).
When adjust voltage and current to reach
the upper limit, is displayed , the
lower limit is displayed as .
When the upper and lower
limits are the same value,it is
displayed as .
To Next Page
