Juntek DPM8600 - Chapter 2 Wireless Controller Instructions; Product Specification

Hangzhou Junce Instruments Co., Ltd.
8
3. Display Introduction
Table 2-4 Display description of DPM8600 series power supply
Display
Display content
introduction
Display
Display content
introduction
Denote the voltage value
Denote the current value
Fast discharge ON
Voltage and current upper
limit setting
Communication protocol
Voltage and current lower
limit setting
MODBUS communication
protocol
Cancel the upper and lower
limits of voltage and current
Baud rate selection of 2.4,
4.8, 9.6, 19.2, 38.4, 57.6 and
115.2 unit (Kbps)
Restore factory settings Off
01 group communication
address, 01-99 total 99
communication addresses
Restore factory settings On
Channel 01, a total of 31
communication channels from
00-30, 00 means not
matching with any wireless
controller
Restoring factory settings
Load a parameter in storage
locations 0-9, 1 means first
Power on default no output
Save the parameters to the
storage locations 0-9, 1 meas
first group
Power on default output
Voltage and current display
calibration
Fast discharge Off
Temperature display

Operating Instructions
1. Instructions for Voltage and Current Adjustment and
Shutdown Output: