Jura E80 - Dismantling and Rinsing the Professional Fine Foam Frother

4
E8/E80/E800 – Quick Reference Guide
T Press the ‘Next’ button.
‘Milk system is being cleaned’ appears and the fine foam
frother and the milk pipe are rinsed with fresh water.
The start screen is displayed.
To make sure the professional fine foam frother works properly, and
in the interests of hygiene, it must be dismantled and rinsed daily if
you have been preparing milk.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Remove the professional fine foam frother.
T Dismantle the professional fine foam frother into its individ-
ual parts.
T Rinse all the parts under running water. If there are severely
dried-on milk residues, firstly immerse the individual parts
in a solution of 250ml cold water and 1 capful of JURA milk
system cleaner. Then rinse the parts thoroughly.
T Re-assemble the professional fine foam frother.
E Ensure that all individual parts are correctly and firmly
connected to ensure optimum operation of the professional
fine foam frother.
Dismantling and rinsing
the professional fine
foam frother
1
2