Jura E6 - User Manual

Other manuals for Jura E6

Quick Reference Guide8 pages

Questions and Answers

M
Marc ReynoldsAug 18, 2025
What to do if little or no water comes out of the Jura E6 Coffee Maker fine foam frother?
- J
  juliemorrisonAug 18, 2025
  If little or no water or steam comes out of the fine foam frother of your Jura Coffee Maker, and the pump is very quiet, the connector of the fine foam frother may be blocked by milk residues or limescale fragments loosened during descaling. Remove the fine foam frother, unscrew the black connector with the aid of the hexagonal hole on the measuring spoon for ground coffee, clean the connector thoroughly, and screw the connector back on tightly by hand.
W
webbmichelleAug 20, 2025
Why does my Jura E6 not recognize that the water tank is empty?
- D
  Dr. Leroy MckayAug 20, 2025
  If you see 'Fill water tank' not displayed on your Jura Coffee Maker, even though the water tank is empty, there is likely a lot of limescale in the water tank. Descale the water tank.
L
Leslie RodriguezAug 22, 2025
How to fix insufficient foam from my Jura E6?
- J
  Jeffrey PattersonAug 23, 2025
  If insufficient foam is produced when frothing milk or milk sprays out of the fine foam frother of your Jura Coffee Maker, the fine foam frother is likely dirty. Clean the fine foam frother or dismantle and rinse it.
R
Richard MunozAug 26, 2025
How to fix insufficient milk foam in my Jura E6 Coffee Maker?
- A
  Amanda HawkinsAug 26, 2025
  If your Jura Coffee Maker isn't producing enough milk foam, or if milk sprays out of the fine foam frother, it's likely that the fine foam frother is dirty. To resolve this, clean the fine foam frother or dismantle and rinse it thoroughly.
C
Charlotte RomeroAug 27, 2025
What to do if my Jura Coffee Maker doesn't display 'Fill water tank'?
- D
  David BrooksAug 28, 2025
  If your Jura Coffee Maker doesn't display the 'Fill water tank' message even when the tank is empty, the water tank probably has a lot of limescale. Descale the water tank.
K
Kenneth JensenAug 30, 2025
Why does coffee only come out in drips from my Jura E6 Coffee Maker?
- E
  Elizabeth TurnerAug 30, 2025
  If coffee only comes out in drips when preparing it with your Jura Coffee Maker, the coffee might be ground too finely, obstructing the system. Adjust the grinder to a coarser setting. Alternatively, the water hardness may not have been correctly set, so perform descaling.
G
Gabriela MorrisonSep 2, 2025
Why is there dry ground coffee behind the coffee grounds container of my Jura E6 Coffee Maker?
- A
  Anita FullerSep 2, 2025
  If there is dry ground coffee behind the coffee grounds container of your Jura Coffee Maker, the beans you are using may be resulting in an above-average volume of ground coffee. Reduce the coffee strength or choose a finer grinder setting.
D
deborahstephensSep 4, 2025
What does error 2 or error 5 mean on a Jura E6 Coffee Maker?
- S
  Stephanie LittleSep 4, 2025
  If your Jura Coffee Maker displays ‘ERROR 2’ or ‘ERROR 5’, and the machine has been exposed to the cold for a long period, heating may be disabled for safety reasons. Warm the machine at room temperature.
B
Brian LawrenceSep 7, 2025
Why does coffee only drip from my Jura E6?
- J
  Jonathan LoweSep 7, 2025
  If coffee is only dripping from your Jura Coffee Maker during preparation, the coffee might be ground too finely, obstructing the system. Try setting the grinder to a coarser setting. Alternatively, the water hardness may not have been correctly set, so perform descaling.
M
mariaroseSep 9, 2025
Why is there little water or steam from my Jura Coffee Maker frother?
- C
  cfoxSep 9, 2025
  If little or no water or steam comes out of the fine foam frother and the pump is very quiet, the connector of the fine foam frother may be blocked by milk residues or limescale fragments loosened during descaling. Remove the fine foam frother, unscrew the black connector with the aid of the hexagonal hole on the measuring spoon for ground coffee, clean the connector thoroughly, and screw the connector back on tightly by hand.

Summary

Important Safety Safeguards

Control Elements Overview

First-Time Setup and Initial Use

Machine Setup and Placement

Initial Machine Operation

Steps for the very first use, including language selection and filter options.

Filter Cartridge Activation

Procedure for activating and inserting a CLEARYL Smart filter cartridge.

Operating Without a Filter Cartridge

Connecting the Milk System

How to connect the milk pipe for frothing milk and preparing milk-based beverages.

Coffee and Milk Preparation

Espresso and Coffee Preparation

Guide to preparing single servings of espresso and coffee.

Preparing Two Coffees

Making a Cappuccino

Step-by-step guide to preparing a cappuccino using the fine foam frother.

Frothing Milk Foam

How to froth milk to create fine, creamy foam for beverages.

Adjusting Water Volume

Adjusting Coffee Grind

Daily Operation and Maintenance

Daily Cleaning Routine

Programming Mode Settings

Product Settings Customization

Adjusting coffee strength, amount, and temperature for specific products.

Automatic Switch-Off Configuration

Machine Maintenance and Cleaning

Machine Rinsing Procedures

Fine Foam Frother Cleaning

Detailed instructions for daily cleaning of the fine foam frother.

Frother Dismantling and Rinsing

Filter Insertion and Changing

Machine Cleaning Program

Running the automated cleaning program using JURA cleaning tablets.

Descaling the Machine

Instructions for descaling the machine to remove limescale deposits.

Jura E6 Specifications

General

Product type	Espresso machine
Certification	TUV
Built-in grinder	Yes
Capacity in cups	16 cups
Number of spouts	2
Coffee input type	Coffee beans, Ground coffee
Coffee maker type	Fully-auto
Appliance placement	Countertop
Water tank capacity	1.9 L
Coffee beans capacity	280 g
Reservoir for brewed coffee	Cup
Number of temperature settings	3
Color name	Platina
Control type	Buttons, Rotary
Display type	TFT
Product color	Black, Platinum
Drip/spout adjustment	Vertical
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0 W
Ristretto making	No
Cable length	1.1 m
Pump pressure	15 bar