19
2 Preparing and using your IMPRESSA for the first time
g T Turn the Rotary Switch until HARDNESS is displayed.
k T Press the Rotary Switch to enter the programme item.
16°dH
g T Turn the Rotary Switch until 25°dH is displayed.
k T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display to confirm the setting.
g T Turn the Rotary Switch until
EXIT is displayed.
k T Press the Rotary Switch to exit programming mode.
READY appears on the display.
T Close the cover of the Rotary Switch.
You can adjust the grinder continuously to suit the roast of your cof-
fee.
If you adjust the fineness of grind when the grinder is not operating,
the grinding wheel could be damaged.
T Only adjust the fineness of grind when the grinder is run-
ning.
The fineness of grind setting is correct if the coffee flows regularly
from the coffee spout. A fine, thick crema is also formed.
Our recommendations:
Z Select a fine setting for a light roast.
U If the fineness of grind setting is too fine, the coffee only
drips from the coffee spout.
Z Select a coarse setting for a darker roast.
U If the fineness of grind is too coarse the coffee flows too
quickly from the coffee spout.
Example: To change the fineness of grind during coffee preparation,
proceed as follows:
T Open the cover of the bean container.
T Remove the aroma preservation cover.
T Place a cup under the coffee spout.
Adjusting the grinder
CAUTION
To Next Page
Loading...
