38
5 Permanent settings in programming mode
g T Turn the Rotary Switch until EXIT is displayed.
k T Press the Rotary Switch to exit programming mode.
READY
T Close the cover of the Rotary Switch.
If the machine is disconnected from the mains, the time has to be
reset.
Precondition:
READY is displayed.
T Open the cover of the Rotary Switch.
k T Keep the Rotary Switch pressed until
RINSE appears.
g T Turn the Rotary Switch until
TIME is displayed.
k T Press the Rotary Switch to enter the programme item.
--:--
g T Turn the Rotary Switch to set the hour.
k T Press the Rotary Switch to confirm the hour setting.
g T Turn the Rotary Switch to set the minutes.
k T Press the Rotary Switch to confirm the minute setting.
OK appears briefly on the display to confirm the setting.
TIME
g T Turn the Rotary Switch until EXIT is displayed.
k T Press the Rotary Switch to exit programming mode.
READY
T Close the cover of the Rotary Switch.
When a switch-on time has been set, the IMPRESSA switches on
every day at the set time and heats up.
E The programmable switch-on time can only be set when the
time has been set.
E The programmable switch-on of your IMPRESSA only works
when the machine is switched on at the power switch
(standby).
Example: To set the programmable switch-on time to
07:30, pro-
ceed as follows.
Precondition:
READY is displayed.
T Open the cover of the Rotary Switch.
k T Keep the Rotary Switch pressed until
RINSE appears.
Time
Programmable
switch-on time
To Next Page
Loading...
