EasyManuals Logo

jurop RV520 User Manual

Default Icon
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
I
NSTALLATION
,
USE AND MAINTENANCE MANUAL
RV360
-
520
R
EV
.
0
9
21-03-2016
19 / 32
Jurop
SpA
Via Crosera n° 50
33082 Azzano Decimo, PN (Italia)
T
EL
.
+39
0
434
636811
F
AX
.
+39
0
434
636812
http://www.jurop.it
e-mail: info@jurop.it
PROBLEMS
Cause Solution
• Insufficient or absent lubrication
• Verif
y oil and rings. Check oil pump efficiency
• Low tank oil level
• Fill tank with oil
• Excessive rotation speed
• Reduce rpm to the prescribed working speed
• Prolonged functioning at max vacuum rate
• Reduce vacuum rate
• Poor ventilation
• Provide en
ough room around the pump. Verify fan conditions. C
lean fan
protections
Vacuum and/or exhaust line of insufficient diameter
Check dimensioning
Cause Solution
• Broken vanes:
• Clean inner chambers, replace vanes
-
due
to infiltrated solids
• Check the secondary shutoff and filters of the suction line
and clean
-
due to insufficient lubrication
• Check the oil pump
• Power transmission breakdown
• Check and replace the damaged parts
• Ice inside the pump (during the cold season)
• Remove ice and slowly start running it.
Avoid suction of water
Cause Solution
• Four way changeover valve in idle position
• Move the lever to vacuum or pressure mode end stroke
• Four way changeover valve n
ot correctly registered
• Adjust the functioning play and lubricate
• Worn vanes
• Replace vanes
• The non
-
return valve leaks
• Clean or replace if necessary
• Worn seal rings
• Replace
• Tank gate valves or gaskets leak
• Replace damaged or worn parts
• Tank connection pipes leak or are obstructed
• Replace damaged pipes
• Obstructed primary shutoff or suction filter
• Remove and clean
• Encrusted exhaust port
• Remove and clean
• Vacuum line components are too small dimensioned
• Verify dimensions
for pump maximum performances
• Obstructed rubber couplings
• Replace
Cause Solution
• Insufficient or absent lubrication
• Check and adjust the lubricating pump
Before scrapping the machine, the following materials need to be
separated and suitably disposed of:
Hydraulic oil.
Rubber and plastic parts, such as hoses.
Steel and aluminium parts.
Recycling materials allow reducing the environmental impact and
respecting the environment.
Do not dispose of in the environment. Dispose of
in compliance with the standards in force.
7
.
Malfunctions: troubleshooting
Unusual oil consumption
Reduced performances
The vacuum pump does not rotate
8.
Scrapping
The vacuum pump overheats

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the jurop RV520 and is the answer not in the manual?

jurop RV520 Specifications

General IconGeneral
Brandjurop
ModelRV520
CategoryWater Pump
LanguageEnglish

Related product manuals