JVA Z14 - 5 Installation; Installation Steps

Page 30 © JVA Technologies Pty. Ltd. www.jva-fence.com
5 INSTALLATION

5.1 INSTALLATION STEPS
1. 
2.            

3. 

not in direct sunlight.
4. 
2 screws.
5. 
 Replace the PCB chassis.
 
the wall.
 
 
10.             
bridge wire from earth out to earth return.
11. 
12. 

13.             

14. Do not connect a live or neutral to the earth terminal.
15. Replace the front cover.
 Turn AC power on.
     
The status light should stop blinking.
 Arm the unit.
 
Ensure that the user understands how to change the User PIN and is in

* NOTE: Keep high voltage and low voltage cables at least 30mm apart. Do
not run high and low voltage cables in the same conduit.