23
English
Adjusting the Audio Input Level
If the sound from the component connected to this unit is
too loud or is not loud enough when changing from another
source to “AUX/MD” (without changing the volume level),
you can change the audio input level through the AUX/MD
jacks.
1
Press AUX/MD so that “AUX/MD” appears in the
main display.
2
Press and hold SET on the remote control for more
than 2 seconds.
• Each time you press and hold the button, the audio
input level alternates between “LEVEL 1” and
“LEVEL 2.”
LEVEL 1: Select when the sound is too loud (initial
setting).
LEVEL 2: Select when the sound is not loud
enough.
If you change the audio input level through the
AUX/MD jacks
The recording level through the AUX/MD jacks also changes.
Selecting “LEVEL 2” rather than “LEVEL 1” makes the sound
recorded louder.
Prohibiting Disc Ejection
You can prohibit disc ejection from the unit and can lock
discs—Disc Lock.
On the main unit ONLY:
To prohibit disc ejection, press and hold 7, then press
REV. MODE when the unit is in standby mode.
“LOCKED” appears in the main display for a while, and
the loaded disc is locked.
If you try to eject the locked disc, “LOCKED” appears to
inform you that the Disc Lock is in use.
To cancel the prohibition and unlock the disc, repeat the
above procedure.
“UNLOCKED” appears in the main display for a while,
and the loaded disc is unlocked.
EN18_23UX_A7DVD[UF].pm6 03.2.26, 9:25 PM23
To Next Page
Loading...
Need help?
General
