EasyManuals Logo

JVC 250 User Manual

JVC 250
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #154 background imageLoading...
Page #154 background image
Chapter 7---Troubleshooting
7-16
Model 250 Service Manual
The Horizontal Vertical Deflection PCB outputs H_OUT_FLYBACK to the Scan
Reversal PCB. This is the horizontal deflection waveform that drives the
horizontal CRT deflection yokes. The H_RED+, GRN+, and BLU+ are the
horizontal deflection returns. The outputs of the vertical amplifier are V_RED+,
GRN+, and BLU+. The returns are V_RED-, GRN-, and BLU-.
The Convergence Deflection PCB receives a sample of the vertical frequency
from the Raster Timing Generator PCB (V_DRIVE) signal and generates a
sawtooth waveform ( V_RAMP). It sends this signal to the Vertical Amplifier on
the Horizontal Vertical Deflection PCB. It also sends geometric correction to
modulate the vertical deflection waveform (V_PARAB) to the Horizontal Vertical
Deflection PCB. The Convergence Deflection PCB sends convergence correction
data received from the System Controller PCB to the Scan Reversal PCB
(X_RED+, GRN+, and BLU+) and (Y_RED+, GRN+, and BLU+). The
convergence correction data goes from the Scan Reversal PCB to the
Convergence Yokes on each CRTs.
The Scan Reversal PCB sends the horizontal and vertical deflection waveforms to
the appropriate CRT. It also converts the waveform for floor/ceiling and front/rear
projector installations.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC 250 and is the answer not in the manual?

JVC 250 Specifications

General IconGeneral
BrandJVC
Model250
CategoryProjector
LanguageEnglish

Related product manuals