JVC A-K100 - Removal Procedures

A-K100 |
2. Insert the wire until its sheathing contacts @) Part No., and name
section “A” of the terminal and pressure-fit the Parts No. : 5298T
terminal clamp at three sections of (a), (), Name : CRIMP PIN
and (c) (section © is especially important to
assure safety. Exercise particular care to
achieve secure clamping).
Terminal : @
A (©)
©
Wire sheathing
3. Removal Procedures
3-(1) Metal cover section 3-(2) Front panel section
1. Remove 5 screws securing the metal cover (2 for 1. Pull out the plastic rivet bushes by pressing it
side panels and 3 for rear panel). from the inside (Fig. 2).
2. Pull out the metal cover backwards. 2. Remove 3 screws from the bottom plate.
Plastic rivet
Fig. 2
3-(3) LED Holder section 3-(4) Level Indicator P. C. Board section
1. Pull out the bass and treble knobs. 1. Remove the LED Holder (refer to 3-(3)).
2. Moving the claw of the LED Holder to the center 2. Remove 4 screws from the LED Holder inside
as shown in the figure below, pull out the LED (Fig. 4).
holder (Fig. 3).
Slide Knob
Fig. 3 Fig. 4
1-3 (No. 2736)