JVC CA-MXG9BK - Page 28

RX-MXG9BK
1-28 (No.20434)
Al Edit or AUTO Edit
i
PRGM Edit or Multi Edit
REVERSE MODE
aS
ap
OIRECT
When you have selected the AI Edit or Auto Edit
Press the SIDE A/B button
The tracks which can fit on side A and B will be automatically
selected in accordance with the specified tape length. By repeatedly
pressing the SIDE A/B button you can check which tracks have been
programmed for which side of the tape.
When you have selected the PRGM Edit or Multi Edit
Select the track numbers for side A with 10 keys.
When you have selected the Multi Edit, you can select tracks from
different discs. After you have selected tracks from one disc, replace
it with the next disc, then select tracks you want.
Press the SIDE A/B button.
Select the track number for side B.
When you have selected the MULTI EDIT you can change discs, and
select up to 10 tracks from one disc.
4. Puta tape in deck B and set the REVERSE MODE selector to the <>
position.
5. Press the FUZZY LOGIC CD REC DIRECT button.
After a blank of 10 seconds is made at the beginning of the tape, the
CA-MXG9BK stores your setting in memory, then the recording will
start. If the inserted tape has not been rewound, it will be rewound
automatically before the recording begins.
(Only for the Multi Edit mode)
When the first disc play ends, deck B enters recording pause mode.
Change the disc and press the FUZZY LOGIC CD REC DIRECT
button, and repeat this procedure until all the programmed discs are
played.
To stop the recording
Press the STOP/CLEAR @ button.
Notes on the PRGM Edit and Multi Edit
To delete the last selected track
Press the CANCEL button on the CD section in stop mode. Each time you press the button,
the last selection will be deleted.
When using Multi Edit, you can only delete the last selected track of the disc loaded on the
tray.To delete the last selected track of another disc, change the disc and press the CANCEL
button.
Page 26