JVC CA-MXG9BK - What Is Fuzzy CD Recording

|
1
;
|
\
|
|
RX-MXG9BK
1-26 (No.20434)
AUTO FADE!
FUZZY LOGIC CD REC
Ome
a
What is Fuzzy CD Recording?
If the recording level is too high, distortion will result; On the other hand, if the
recording level is too low, the sound volume will be low. So, it is very important
to check the peak level of the source tracks before recording. Furthermore, it is
necessary to check the tracks' overall level. With the Fuzzy CD Recording
feature, if the tracks’ overall level is high, the recording level will be set lower,
and, if the tracks’ overall level is low, the recording level will be set higher. In this
way, the optimum recording level is set according to the sound inclination of the
tracks as well as the peak level. The conventional peak search function does not
take into account the tracks’ overall balance when setting the recording level;
therefore, the recording level tended to be low. Fuzzy CD Recording gives a
balanced recording level which matches different kinds of tracks.
Fuzzy CD Recording
1. Load a CD in the tray.
2. Puta tape in deck B.
3. Select the side to record on, by pressing either the < or > button while
pressing the @ button on deck B.
4. Press either FUZZY LOGIC CD REC AUTO FADE or DIRECT button.
The tape starts recording 10 seconds before the CD starts, making a
10 second blank at the beginning of the tape to insure the entire
selection is recorded.
If the last recorded track cannot fit on side A, it will be re-recorded with fade
-out.
+ When REVERSE MODE is set to either 2 or c25 , side B recording will start
after a blank portion of 10 seconds is made. The recording will continue with
the last track recorded with a fade-out on side A.
* The last track on side B will end by fading-out.
+ If the inserted tape has not been rewound, it will be rewound automatically
before recording begins.
To stop recording
Press the ™ button on deck B or the STOP/CLEAR @™ button on the CD player.
Note
The tracks can be recorded with a specified sound effect (SEA pattern and DSP modes).
Sound effects cannot be changed during recording.
AUTO FADE starts the recording with AI Edit (page 25) and
Fade mode (page 23).
* When FUZZY LOGIC CD REC (either AUTO FADE or
DIRECT) is pressed, the optimum recording level will be
determined by the fuzzy search, then the recording will
start from the first CD track. (Since the fuzzy search will
search the entire CD, it will take a little time.)
« During the fuzzy search, the track number, number of
tracks, playing time, etc., will change accordingly.
Page 24