JVC CA-MXG9BK - Receiving Radio Broadcasts; Using the Bandwidth Memory; Using Auto Preset Function

RX-MXG9BK
Ye"
The controls for the radio are located in the Tuner/Amplifier section. With these controls you can browse through all the stations or use the preset
function to go immediately to a particular station. For tuning stations manually, see page 8 of the Easy Guide section.
Receiving Radio Broadcasts
Using the Bandwidth Memory
Ls Storing Preset Stations
a NIN@TICRIDOAAEA & Once a station is assigned to a channel number, the station can be quickly tuned
= = either from the Remote using the 10 keys or from the CA-MXG9BK itself using
: the PRESET < or > button to call up the channel number.
( To preset radio stations
1. Tune in the station you want to set (see page 8 in the Easy Guide section).
.
2. Press the MEMORY button.
On the Tuner/Amplifier display, MEMORY will blink for 5 seconds.
During these 5 seconds while MEMORY is blinking you can assign
a channel number to the station and enter it into the memory.
7)
. Select achannel number by pressing the PRESET < or > button until you
find the channel number you want.
If you select a number you have already assigned, the previous
selection will be erased and replaced by the new station.
4, Press the MEMORY button again and the station will be assigned to the
channel number showing on the display.
Up to 10 stations each for the FM and AM bands can be preset.
To cancel presetting :
Press the CANCEL button.
On the display, CANCEL will blink for 5 seconds. During these 5
seconds for which CANCEL is blinking, you can select the station
you want to erase. Press the CANCEL button again.
CAUTION: Preset stations may be erased when power is cut off
to the Unit, as when it is unplugged from the AC outlet or a
power failure occurs. If the preset stations are lost, simply set
the stations again using the above procedure.
Using Auto Preset Function
The CA-MXG9BK will automatically preset AM or FM stations.
1. Press the FM or AM button.
2. Press the MEMORY button.
On the display MEMORY will blink for 5 seconds. During these 5
seconds for which MEMORY is blinking you can use the Auto Preset
mode.
3. Press the PRESET SCAN button.
Regardless of whether FM or AM is selected, the automatic search
will start with the FM stations. After the FM preset operation is
completed, the AM preset operation will begin. Up to 10 stations each
for the FM and AM bands can be preset.
When a station is found, it will be received for about 5 seconds. If you
PRESET SCAN do not want to preset the station, press the PRESET SCAN button
again while receiving the station and the station will be skipped.
Page 27
(No.20434) 1-29