JVC CA-MXG9BK - Using Continuous Play; Skipping Blank Portions During Playback; Using the DOLBY NR Selector

REVERSE MODE
eas
=>
{
deck A > | | deck B < | :
t
BLAN SKIP
wag
a
Sx
DOLBY NR
FF c
DOLBY NR
OFF B Cc
Page 21
=p
RX-MXG9BK
Using Continuous Play
When
you
play
tapes,
you
can
select
the
side
to
be
played
by
using
the
REVERSE
MODE
selector.
only one side is played
both sides are played
both sides are played repeatedly.
When tapes are in both decks, continuous play follows
the sequence at the left regardless where playback starts.
» The sequence is repeated endlessly.
oun
Skipping Blank Portions during Playback
If there is a blank portion of 10 seconds or longer on a tape, the Unit will
automatically fast forward, and skip the blank portion, then play back the next
track.
#
Press the BLANK SKIP button before or during play.
The LED next to it lights up.
To cancel the blank skip playback
Press the BLANK SKIP button again.
The LED next to it goes off.
Using the DOLBY NR * selector
To play a tape recorded with the Dolby Noise Reduction effect, set the DOLBY
NR selector to the same NR system (DOLBY B NR or DOLBY C NR)as was used
when recording.
If a tape is recorded with the Dolby NR system, playing it back with the same
Dolby NR system wiil reduce tape hiss and improve the clarity of the sound.
Note:
Dolby NR is inactive in dubbing mode regardless of the setting of the NR switch. The dubbed
tape automatically contains the same processing as the source tape.
* Dolby noise reduction and HX Pro headroom extension manufactured under license from
Dolby Laboratories Licensing Corporation. HX Pro originated by Bang & Olufsen.
“DOLBY” , the double-D symbol, and “HX PRO” are trademarks of Dolby Laboratories
Licensing Corporation.
(No.20434) 1-23