JVC CA-MXGT88

Listeningto the Radio
Tuningin toa Station--Auto Search
1Press FM/AM.
The unit automatically turns on and tunes
in to the previously tuned station (either
FM or AM--MW),
• Each time you press the button, the hand alternates
between FM and AM (MW).
2 Start searching for stations.
On the unit: ....... ..................'......
Press and hold _
TUNING + or
TUNING - for more
than 1 second.
On the remote control:
Press and hold 1_41/_141
or I_l/l_ for more than
1 second.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in to.
If a program is broadcast in stereo, the ST (stereo)
indicator lights up.
To stop during searching, press TUNING + or TUNING -
(or I,_1_/41_ or I_t/l_ on the remote control).
When you press TUNING + or TUNING -
(or F._/.._.9 or _...t/_t_ on the remote control) briefly
and repeatedly
The frequency changes step by step.
Tochangethe FM receptionmode
When an FM stereo broadcast is hard to receive FM MODE
or noisy, press FM MODE on the remote control
so that "MONO" appears and the MONO
indicator also lights up on the display. Reception
improves.
To restore the stereo effect, press FM MODE again so that
"STEREO" appears on the display.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.
PresettingStations
You can preset 30 FM and 15 AM (MW) stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
On the unit ONLY:
1 Tune in to the station you want to preset (in
this example, of FM 87.50).
• See "Tuning in to a Station--Auto Search,"
I_d R "--Ii--I--I
Fll _ 1.23u
2 Press SET. ....
........23 C i ...........
3 Turn the PRESET +/- control
to select a preset number.
4 Press SET again.
5T RE ,,
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
_When the AC cord or ira
you unplug
power power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset fhe stations again.
Tuningin toa PresetStation
1Press FM/AM.
• See "Tuning in to aStation--Auto
Search," step I for details.
2 Select a preset number.
On the unit:
Turn the PRESET +/- control.
On the remote control:
Press the number buttons.
Ex.: For preset number 5, press 5.
For preset number 15,
press +i0 then 5.
For preset number 20,
press +i0, lhen 10.
CD OD C]D
C]D Ci1_ C]D
C!D OD C]D
®
For preset number 25, press +10, +i0, then 5,
For preset number 30, press +10, +i0, then 10,
12