JVC CA-MXGT88

Continued I_
Programmingthe PlayingOrderofthe Tracks
mProgram Play
You can arrange the order in which the tracks play before you
start playing. You can program up to 32 tracks.
• To use Repeat play (see page 21) for Program play, press
REPEAT after starting Program play.
• This function does not work for MP3 discs.
On the unit ONLY:
1Load CDs.
• If the current playing source is not the CD player, press
CD I_/11, then • before going to the next step.
2 Press PROGRAM so that f_]
"PROGRAM" appears on the
display.
The PRGM (program) indicator also lights up on the
display.
• All Disc play is selected automatically. You cannot
select One Disc play for Program play.
TRACK
PP RR,,
_.-" Ilgt ALLD_C
• If a program has been stored in memory, the program is
called up.
3 Press one of the disc
number buttons (CD1, CD2,
and CD3) to select the disc
number you want to play.
Disc number
CD1 CD2 CD3
%,
Program step number
Track number
4Turn the 1_141!IP-I_lcontrol to select
the track number, then press SET.
Each time you select a track and press SET,
the selected track number is added lo the
track number indicator.
• You can select up to 1he 99th track on each
disc.
TRACK
Ill
"" i'_
P
A[[ Disc
5 Program other tracks you want.
• To program 1racks from the same disc, repeat step 4.
• To program 1racks from a different disc, repeat steps 3
and 4.
O Press CD I_/11.
The tracks are played in the order you
have programmed.
To stop during play, press •.
To exit from Program play, press PROGRAM again before
or after play so that the unit enters All Disc play. (The
program you have made is stored in memory until you turn
off file unit, eject the carrousel, or erase the program.)
• Program play is also canceled when you press A.
To modifythe program
Before playing, you can erase the last
programmed track shown on the display by
pressing CANCEL_EMO.
• Each time you press the button, the last programmed track
is erased from the program.
To check the program during play, perform the following
procedure:
• You can check only flae programmed tracks on flae current
disc at one time.
1 Press CD I_/11to pause Program play.
2 Turn the l<l</l_lP.t control.
The programmed tracks on the currently selected disc
appear on the display in the programmed (or reverse) order.
• If tracks on another disc have been programmed,
"PAUSE" appears on the display.
To check the programmed tracks on another disc, press
CD I_111twice, then turn the l<l</l_,q control.
• Pressing CD I_/11 again starts Program play from the track
currently shown on the display.
To add tracks in the program before play, simply select the
disc numbers and/or track numbers you want to add by
following steps 3 and 4 of the programming procedure.
To erase the entire program before or during play, press •
twice.
• Turning the power offor ejecting the carrousel will also
erase fl_e stored memory.
_ If you try to program a 33rd track
"FULL" will appear on the display.
_ f you have programmed a track ti'om an empty tray,
or a track number that does not exist on the disc
Such program steps will be skipped.
_If there is an MP3 disc on the disc tray
Even if you add tracks on the MP3 disc to the program in step 3 to 5,
those tracks will be skipped.
20