JVC CA-MXGT88

Usingthe Timers
There are three timers available--Daily Timer, Recording
Timer, and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit. (See "Selting the Clock" on page 9.)
UsingDailyTimer
With Daily Timer, you can wake to your favorite music or
radio program. You can set the timer whether the unit is on or
off.
HowDailyTimer actuallyworks
The unit automatically turns on, set the volume level to the
preset level, and starts playing the specified source when the
on-time comes (the O indicator flashes while the timer is
operating). Then, when the off-time comes, the unit
automatically turns off (stands by).
Daily Timer works every day unless you cancel it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step I again.
• If you have made a mistake while setting timer, press
CANCEL/DEMO. (However, this does not always work. If
CANCEL/DEMO does not work, press CLOCK/TIMER
repeatedly and start from slep 1 again.)
Before you start.,,
• When using a CD as the source toplay:
_Make sure there is a CD on the currently selected
disc number tray.
• When using a tape as the source to play:
_Make sure that a tape is in the deck whose deck
indicator (A or B) is lit on the display.
• When using the external component as the source to
play:
--Set the timer equipped with the external component
at the same time.
On the unit ONLY:
1Press CLOCK/TIMER
repeatedly until "DAILY"
appears on the display.
O indicator lights up and the DAILY (daily timer)
indicator starts flashing on the display.
,'-IRT'_.'-,-'
• Each time you press the button, the clock!timer setting
modes change as follows:
_r. DALLY _ ON TIME _ REC
7
(Daily Timer) 1
Canceled _CLOCK_'-- ON TIME _'_
(See page 9) (Recording Timer)
2 Press CLOCK/TIMER again.
"ON TIME" appears for 2 seconds, then
the unit enters on-time setting mode.
=AIL_
3 Set the on-time you want the unit
to turn on.
1) Turn the I,,11_1/1_1control to set the hour,
then press SET.
2) Turn the I_1_/1_t control to set the minule,
then press SET.
"OFF TIME" appears for 2 seconds, then /,_--SEg_T _]
the unit enters off4ime setting mode.
4 Set the off-time you want the unit
to turn off (on standby).
1) Turn the l-.4_l/It..t_l control to set the hour,
then press SET.
2) Turn the I_l_/It..t_l control to set the minule,
then press SET.
The unit enters source selecting mode.
U ! _1k ! _ ....... ! I
25