- 5 -
Eciency at low load
(10%)
87.65 % Declared by the manufacturer
based on the value cal-culated at
load condition 5. External power
supplies with a nameplate output
power of 10 W or less shall be
exempted from this requirement. In
cases where multiple average active
eciencies are declared for multiple
output voltages available at load
condition 1, the value published
shall be the value declared for the
lowest output voltage.
No-Load power
consumption
0.064 W Declared by the manufacturer
based on the value measured for
load condition 6.
The relevant load conditions are as follows:
Percentage of nameplate output current
Load condition 1 100 % ± 2 %
Load condition 2 75 % ± 2 %
Load condition 3 50 % ± 2 %
Load condition 4 25 % ± 2 %
Load condition 5 10 % ± 1 %
Load condition 6 0 % (no-load condition)
EMC Supplement
This equipment is in conformity with the provisions and protection requirements of the
corresponding European Directives.
In order to keep the best performance and ensure electromagnetic compatibility, we
recommend to use cable not exceeding the following length:
Cable Length
Power cord (attached cable) 1.8 m
VGA cable (attached cable) 1.8 m
Audio cable (attached cable) 1.6 m
USB cable (attached cable) 1.8 m
DVI cable (shielded cable) 2.0 m
RS-232 cable (shielded cable) 1.8 m
CAUTION
:
In case where the strong electromagnetic waves or magnetism are near the audio cable
or the signal cable, the sound or the picture will contain noise.
In such cases, please keep the cable away from the sources of the disturbance.
To Next Page
Loading...