ENGLISH
35
Getting Started
Preparation
Basic Operation
Troubleshooting
Settings
Others
Input Signal > HDMI
11
HDMI
Congures HDMI input signal.
Input
Auto Automatically congures the input signals.
Standard
Select this when the dynamic range of the input images is
16-235.
Enhanced
Select this when the dynamic range of the input images is
0-255.
Color Space
Auto Automatically congures the input signals.
YCbCr(4:4:4)
Select this when the Y Cb Cr(4:4:4) video signals are
input.
YCbCr(4:2:2)
Select this when the Y Cb Cr(4:2:2) video signals are
input.
RGB Select this when the RGB video signals are input.
Control with HDMI
On Enables CEC communications.
Off Disables CEC communications.
● The setting is available only if the HDMI terminal is selected.
● Abbreviation
CEC: Consumer Electronics Control
Input Signal > COMP.
12
COMP.
Congures the input signal for the component video input terminals.
Color Space
Y Pb/Cb Pr/Cr Select this when the component video signals are input.
RGB Select this when the RGB video signals are input.
SCART
Select this when RGB video signals and sync signals are
input via the SCART interface for European markets.
● The setting is available only if the component video terminals are selected.
Input Signal > Video/S-Video
13
Video/S-Video
Congures the Video/S-Video input signals.
NTSC Setup Level
0IRE Adjusts the gradation for signals without the 7.5 IRE setup.
7.5IRE Adjusts the gradation for signals with the 7.5 IRE setup.
●
Adjust this only when NTSC signals are input via Video or S-Video terminal.
Color System
Auto Congures the color system automatically.
NTSC Select this when the color system is NTSC.
NTSC4.43 Select this when the color system is NTSC4.43.
PAL Select this when the color system is PAL.
PAL-M Select this when the color system is PAL-M.
PAL-N Select this when the color system is PAL-N.
SECAM Select this when the color system is SECAM.
● The setting is available only when the Video or S-Video input image is projected.
To Next Page
Loading...
Need help?
General
