OPERATIONS
35
ENGLISH
USB operations
You can connect a USB mass storage class device such as a USB memory, Digital Audio Player *
1
, portable HDD, etc.
to the unit.
~
Ÿ
Press [SOURCE], then press [USB]. (☞ page 9)
• You can also use SOURCE on the monitor panel. Press it repeatedly.
This unit can play the DivX/JPEG/MPEG1/MPEG2*
2
/
MP3/WMA/WAV/AAC*
3
files stored in USB mass
storage class device.
• You can operate the USB device in the same way you
operate the files on discs (except OSD operation and
those on the external monitor). (☞ page 18 to 28)
• All tracks in the USB device will be played repeatedly
until you change the source.
• You cannot select “USB” when Dual Zone is in use.
• Make sure all important data has been backed up.
*
1
Except for JVC D. Player XA-HD500.
*
2
Except for MPEG2 files recorded by JVC Everio
camcorder (extension code <.mod>).
*
3
This unit can play back AAC files encoded using
iTunes. This unit cannot play back AAC files purchased
from the iTunes Store.
USB cable from the rear of the unit
•
You cannot connect a computer to the USB ( ) terminal of the unit.
Caution:
• Avoid using the USB device if it might hinder your
safety driving.
• Do not pull out and attach the USB device
repeatedly while “Now Reading...” is flashing on
the monitor screen.
• Do not start the car engine if a USB device is
connected.
• Stop playback before disconnecting a USB device.
• Do not leave a USB device in the car, expose to
direct sunlight, or high temperature to avoid
deformation or cause damages to the device.
EN16-36_KW-AVX800E_f.indd 35EN16-36_KW-AVX800E_f.indd 35 07.2.13 10:06:33 PM07.2.13 10:06:33 PM
To Next Page
Loading...
