JVC GR-D770AG

EN 15
GETTING STARTED
MasterPage: Start_Right
GETTING STARTED
The date/time is recorded onto the tape at all
times, but its display can be turned on or off.
( pg. 34, 35)
Perform steps 1 – 3 in “Language Settings”
( pg. 14).
1 Select “DISPLAY”, press SET or 2.
2 Select “CLOCK ADJ.”, press SET or 2.
3 Select the desired date display format,
press SET or
2.
● Repeat this step to input time display format
(Select from “24h” or “12h”), month, date, year,
hour and minutes.
4 Press MENU.
Press 1 whenever you want to return to the
previous menu screen/setting.
1 Set the Power Switch to “REC” while
pressing down the Lock Button located on the
switch.
2 Make sure the LCD monitor is closed and
locked. Pull out the viewfinder fully.
3 Turn the Dioptre Adjustment Control until
the indications in the viewfinder are clearly
focused.
CAUTION:
When retracting the viewfinder, take care not to
pinch your fingers.
Perform steps 1 – 3 in “Language Settings”
( pg. 14).
● To adjust the brightness of the viewfinder,
pull out the viewfinder fully and set
“PRIORITY” to “FINDER” ( pg. 34).
1 Select “DISPLAY”, press SET or 2.
2 Select “BRIGHT”, press SET or 2.
3 Select the appropriate brightness, press
SET or
2.
4 Press MENU.
Press 1 whenever you want to return to the
previous menu screen/setting.
To attach the
camcorder to a tripod,
align the direction stud
and screw to the
mounting socket and
stud hole on the
camcorder. Then
tighten the screw
clockwise.
● Some tripods are not
equipped with studs.
Date/Time Settings
Viewfinder Adjustment
CLOCK ADJ.
DATE. MONTH. YEAR 24 h
21 : 38 AM
11. 09 . 2007
1 Select
2 SET
Dioptre Adjustment Control
Example:
Brightness Adjustment Of The
Display
Tripod Mounting
BRIGHT
– 0
1 Select
2 SET
GR-D770AG_EN.book Page 15 Tuesday, December 5, 2006 1:47 PM