EN 23
MasterPage: Start_Right
Menus For Detailed Adjustment
ENGLISH
The “DISPLAY”
settings except (“CLOCK ADJ.”, “16:9 OUTPUT” and “BRIGHT”) are effective only
for shooting.
Menus Settings: [ ] = Factory-preset
TAPE
REC MODE
[SP]*: To record in the SP (Standard Play) mode
LP: Long Play - more economical, providing 1.5 times the recording
time.
* SP indicator does not appear on the screen.
Notes:
● If the recording mode is switched, the playback picture will be blurred at the
switching point.
● It is recommended that tapes recorded in the LP mode on this camcorder
be played back on this camcorder.
● During playback of a tape recorded on another camcorder, blocks of noise
may appear or there may be momentary pauses in the sound.
SOUND
MODE
[12BIT]: Enables video recording of stereo sound on four separate
channels. (Equivalent to the 32 kHz mode of previous
models).
16BIT: Enables video recording of stereo sound on two separate
channels. (Equivalent to the 48 kHz mode of previous
models).
Menus Settings: [ ] = Factory-preset
DISPLAY
ON SCREEN LCD: Keeps the camcorder’s display (except the date, time and
time code) from appearing on the connected TV screen.
[LCD/TV]: Makes the camcorder’s display appear on screen when the
camcorder is connected to a TV.
DATE/TIME [OFF]: The date/time does not appear.
ON: The date/time is always displayed.
CLOCK ADJ. 墌 14, “Date/Time Settings”.
TIME CODE [OFF]: Time code is not displayed.
ON: Time code is displayed on the camcorder and on the connected
TV. Frame numbers are not displayed during recording. (墌
17)
16:9
OUTPUT
To enable your tv to display images in 16:9 wide mode, set the tv screen
size correctly.
[4:3TV]: For TV with an aspect ratio of 4:3.
16:9TV: For TV with an aspect ratio of 16:9.
BRIGHT 墌 15, “Brightness Adjustment Of The Display”.
GR-DA20EK.book Page 23 Thursday, August 2, 2007 12:08 PM
To Next Page
Loading...
Need help?
General
