34 EN
Troubleshooting
* The camcorder turns off automatically. Re-check if the indication clears. When it does, you can resume
using the camcorder. If the indication remains, consult your nearest JVC dealer.
Problem Possible Cause Remedy
The POWER/CHARGE lamp
on the camcorder does not
light during charging.
●
Charging is difficult in places
subject to extremely high/low
temperatures.
●
The battery pack is not
attached firmly.
H
To protect the battery, it is
recommended to charge it in places
with a temperature of 10°C to 35°C.
(
墌
35)
H
Detach the battery pack once again
and re-attach it firmly. (
墌
13)
The tape is moving, but there
is no picture.
●
Your TV has AV input
terminals, but is not set to its
VIDEO mode.
●
The cassette holder cover is
open.
H
Set the TV to the mode or channel
appropriate for video playback. (
墌
20)
H
Close the cassette holder cover.
(
墌
15)
Blocks of noise appear
during playback, or there is
no playback picture and the
screen becomes blue.
H
Clean the video heads with an optional
cleaning cassette.
Data battery status does not
appear.
●
The AC Adapter is
connected to the camcorder.
●
The camcorder turned off
automatically.
H
Disconnect the AC adapter from the
camcorder.
H
Turn the camcorder off, then on again.
Warning Indication Meaning / Remedy
●
Displays the battery remaining power.
●
As the battery power comes close to nil, the battery remaining power
indicator blinks. When the battery power is exhausted, power turns off
automatically.
SET TO MANUAL MODE
●
Appears when you attempt to change “Menu Settings”, “Backlight
Compensation” or “Manual Focus” while in AUTO mode
A
. (
墌
11)
TAPE END
●
Appears when the tape ends during recording or playback.
LENS CAP
●
Appears for 5 seconds after power is turned on if the lens cap is
attached or when it is dark.
SET DATE/TIME!
●
Appears when the date/time is not set. (
墌
14)
●
The built-in clock battery has run out and the previously set date/time
has been erased. Consult your nearest JVC dealer for replacement.
●
Appears if a tape is loaded while the Power Switch is set to
“REC”
.
●
Blinks when no tape is loaded.
CHECK TAPE’S ERASE
PROTECTION TAB
●
Appears when the erase protection tab is set to “SAVE” while the
Power Switch is set to
“REC”
.
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY OR
DC PLUG
●
Error indications (01, 02 or 06).
Remedy: Remove and reattach the power supply or battery*.
UNIT IN SAFEGUARD
MODE EJECT AND
REINSERT TAPE
●
Error indications 03 or 04.
Remedy: Eject the cassette and re-insert*.
High
Exhausted
GR-DA20EK.book Page 34 Thursday, August 2, 2007 12:08 PM
To Next Page
Loading...
Need help?
General
