JVC GR-DV1

17
TW
RM-V708U Remote Control Unit
You can use the RM-V708U to control the camcorder when it’s attached to the Docking Station.
1
PULL OUT BATTERY HOLDER
Pull out in the direction of the arrow while
pressing the lid as shown.
2
INSERT BATTERY IN HOLDER
With the “+” side up, place the lithium battery
(CR2025) in the holder.
3
RE-INSERT HOLDER
Slide the holder back in until you hear a click.
Operation Buttons
(
Z pg. 50)
INSERT Button (Z pg. 60)
UP Button (Z pg. 50)
Installing The Battery
The RM-V708U uses one lithium battery (CR2025).
MBR SET Button (
Z pg. 53)
AUDIO MONITOR
Button (Z pg. 59)
DOWN Button (Z pg. 50)
AUDIO DUBBING
Button (Z pg. 59)
R.A. EDIT Buttons (
Z pg. 54)
PAUSE IN connector (
Z pg. 54)
ZOOM Buttons (
Z pg. 50)
DISPLAY Button (Z pg. 59)
SHIFT Button (Z pg. 50)
SLOW Rewind/Forward
Buttons (
Z pg. 45)
LEFT/RIGHT Buttons
(Z pg. 50)
FADER/WIPE Button
(Z pg. 54)
EFFECTS ON/OFF
Button (Z pg. 51)
EFFECT Button
(Z pg. 51)
RECORDING START/STOP Button (Z pg. 60)
POWER ON/OFF Button
When the camcorder’s Power
Dial is set to “PLAY”, you can
turn the unit’s power on and off
using the RM-V708U.
KNOB
CANCEL Button (Z pg. 55)