24
Tape Remaining Indicator
The time remaining on the tape is automatically
monitored and displayed in the viewfinder
(Z pg. 66). When the tape ends, “TAPE END”
appears in the viewfinder.
Re Shoot A Scene
If you aren’t pleased with a scene you just recorded
(after having checked it in the viewfinder), you can
easily return to the beginning and record it again.
1
ENGAGE RECORD/STANDBY MODE
Press RECORDING START/STOP, then press
RE SHOOT. The tape returns automatically to
the starting point of the most recent recording,
and the camcorder enters RECORD/STANDBY
mode.
•If, after the tape has rewound to the
beginning of the scene, you decide you don’t
need to re-record, press CAN. The tape auto-
matically fast-forwards to the end of the scene.
REC
30min
29 min
3 min
2 min
blinking
1 min
blinking
0 min
blinking
Stable Shooting Positions
CAN. BUTTON
RECORDING (Cont.)
RE SHOOT BUTTON
Before pressing RECORDING START/
STOP, ZOOM or SNAP SHOT, be sure to
hold the camcorder with both hands.
For low
shooting
Feet set slightly
apart with your
body turned
toward the
subject
Fasten hand strap around wrist
Lean against a wall
or pole for support
To Next Page
Loading...
Need help?
General
