24 EN
LCD Monitor/Viewfinder Indications
You can make the LCD monitor/Viewfinder
indications appear/disappear.
1
PRESS IND.ON/OFF BUTTON
When you do not want the indications to
appear, press the IND.ON/OFF button
for longer than approximately 1 second.
Certain indications disappear.
Press again for longer than approx. 1 second to
make the indicaitons reappear.
NOTE:
It is impossible to make the tape running indicator
and warnings etc. disappear from the LCD monitor
or the viewfinder. For the indications that can be
removed,
Z
pg. 78
Brightness Control
You can adjust the brightness of the LCD monitor by
rotating the Select Dial.
1
ADJUST BRIGHTNESS
If you want to brighten the image...
Rotate the Select Dial upward until the
brightness indicator moves and the LCD
monitor reaches its appropriate brightness.
If you want to darken the image...
Rotate the Select Dial downward until the
brightness indicator moves and the LCD
monitor reaches its appropriate brightness.
•The brightness indication appears in the LCD
monitor.
90 min
REC
89 min 3 min 2 min
1 min0 min
Tape Remaining Indicator
The time remaining on the tape is automatically monitored and displayed (Z pg. 78). When the tape ends,
“TAPE END” appears. If the indications are turned off, the tape remaining indicator appears when remaining
time reaches 2 minutes.
blinking
blinkingblinking
– – – – – – – – – –
6
BRIGHT
MENU
RECORDING
(Cont.)
Display
IND.ON/OFF button
Select Dial
To Next Page
Loading...
Need help?
General
