Preparing a DVD Writer (CU-VD3)
1
Close the LCD monitor and connect.
.
① Connect the AC adapter to this unit.
② Connect the AC adapter of the DVD writer.
③ Connect the USB cable of the DVD writer to this unit.
●
Refer also to the instruction manual of the DVD writer.
2
Insert a new disc.
.
① Press the eject button to open the disc tray.
② Pull out the tray completely and load a new disc properly.
③ Push the disc tray in until it clicks into place.
3
Open the LCD monitor.
.
●
This unit turns on and the BACK-UP menu appears.
●
While the USB cable is connected, the BACK-UP menu is displayed.
CAUTION:
●
Be sure to turn off the power when connecting the devices.
Otherwise, electric shocks or malfunctions may occur.
Preparing an External Blu-ray Drive
Memo:
When connecting to the external Blu-ray drive, use a USB cable with
Mini-A (Male) – B (Male) connectors.
The USB cable bundled with this camera cannot be used.
To use the USB cable provided with the external Blu-ray drive, purchase
the USB extension cable.
●
Mini-A (Male) – A (Female)
(Part number: QAM0852-001)
1
Close the LCD monitor and connect.
.
① Connect the AC adapter to this unit.
② Connect the AC adapter of the external Blu-ray drive.
③ Connect the USB cable of the external Blu-ray drive to this unit.
●
Refer also to the instruction manual of the external Blu-ray drive.
2
Insert a new disc.
●
Press the power button on the external Blu-ray drive to turn on the
power.
.
① Press the eject button to open the disc tray.
② Pull out the tray completely and load a new disc properly.
③ Push the disc tray in until it clicks into place.
3
Open the LCD monitor.
.
●
This unit turns on and the BACK-UP menu appears.
●
While the USB cable is connected, the BACK-UP menu is displayed.
CAUTION:
●
Be sure to turn off the power when connecting the devices.
Otherwise, electric shocks or malfunctions may occur.
Copying
86
To Next Page
Loading...
