14 EN
Controls in this section
Necessary Settings before Use
Be sure to configure the following three settings
before use.
Power Related Preparations
(Using the Battery Pack)
1
Set the power switch to OFF.
Slide while pressing down the lock button.
2
Attach the battery pack.
Slide the battery pack down until it locks in
place.
Power off
Playback
Recording
Lock button
Bottom of the Camera
BATT.
To detach the battery pack
Slide and hold BATT. (墌 step 2), then remove
the battery pack.
To check the remaining battery power
(墌 pg. 16)
Required charging / recording time
The times shown above are approximate times.
3
Charge the battery pack by
connecting to the AC adapter.
● The power/charge lamp blinks to indicate
charging has started.
● When the lamp goes out, charging is
finished. Unplug the power cord from the
AC outlet and disconnect the AC adapter
from the camera.
Battery pack Charging time
Recording
time
BN-VF707U
(Provided)
1 hr. 30 min. 1 hr.
BN-VF714U 2 hr. 40 min. 2 hr. 5 min.
BN-VF733U 5 hr. 40 min. 4 hr. 55 min.
NOTE:
You can also use the camera with just the AC
adapter.
Open the cover.
DC
Connector
To AC Outlet
(110V to 240V)
AC Adapter
(ex. AP-V14A)
Power Cord
MENU
INDEX
Power Switch
/ /// 49
Power/Charge Lamp
M6E6Asia.book Page 14 Friday, March 24, 2006 5:38 PM
To Next Page
Loading...
Need help?
General
