JVC GZ-MS100E Series User Manual

14
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camcorder.
2
Attach the battery pack.battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camcorder
BATT.
3
Connect the AC adapter.
•
If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
The charge lamp blinks to indicate charging
has started.
•
When the lamp goes out, charging is
finished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camcorder.
L
To detach the battery pack
Slide and hold BATT. ( step 2), then
remove the battery pack.
L
To check the remaining battery power
See page 15.
NOTES
•
You can also use the camcorder with just
the AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
Necessary Settings before Use
DC Jack
AC Adapter
To AC Outlet
(110V to 240V)
Date/Time Setting
1
Open the LCD monitor to turn on the
camcorder.
2
When [SET DATE/TIME!] appears,
select [YES] within 10 seconds.
SET DATE/TIME!
YES
NO
If you do not select within 10 seconds, the
screen disappears. In such case, press
the button and turn the camcorder on
again.
3
Set the date and time.
DATE TIME
CLOCK ADJUST
31 1 11 07
2008
Repeat this step to input the month, day,
year, hour and minute.
4
Touch the OK button to finish.
L
To change the date and time
1) Touch the
MENU button.
2) Select [BASIC SETTINGS], and then
[CLOCK ADJUST].
3) Set the date and time.
L
To return to the previous screen
Select
@
.
L
To quit the screen
Touch the MENU button.
Charge
Lamp

JVC GZ-MS100E Series Specifications

General

Brand	JVC
Model	GZ-MS100E Series
Category	Camcorder
Language	English