JVC HR-DVS2U - Set DBS Receiver Output Channel & DBS Receiver Brand

EN 19
Set DBS Receiver Output
Channel & DBS Receiver
Brand
TURN ON DBS RECEIVER
1
Select a channel other than channel 55, 100 or 205 on
your DBS receiver.
TURN ON THE VCR
2
Press POWER.
● Set the VCR to the channel (3 or 4 or F-1 or L-1) on
which the signals from the DBS receiver are received.
ACCESS MAIN MENU
SCREEN
3
Press MENU.
ACCESS INITIAL SET
SCREEN
4
Press %fi to move the highlight bar (arrow) to “INITIAL
SET”, then press OK or # .
ACCESS DBS RECEIVER SET
SCREEN
5
Press %fi to move the
highlight bar (arrow) to
“DBS RECEIVER SET”, then
press OK or # .
SELECT DBS RECEIVER
OUTPUT CHANNEL
6
Your selection depends on
how your DBS receiver is
connected to your VCR.
If your DBS receiver is
connected to your VCR
using an RF connection . . .
. . . press %fi until the
channel number
representing the DBS receiver's output (CH3 – CH4)
appears on the screen.
If your DBS receiver is connected to your VCR’s REAR
AUDIO/VIDEO IN connectors . . .
. . . press %fi until "ON L-1 (REAR)" appears on the
screen.
123
456
7
89
0
2
4
1
3
T W
DV S-VHS
POWER
POWER
CONTINUED ON NEXT PAGE
Turn on the TV and select the AV mode.
MENU
OK
INITIAL SET
CLOCK SET
LANGUAGE ENGLISH
GUIDE CHANNEL SET
CABLE BOX SET
=DBS RECEIVER SET
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
DBS RECEIVER SET
OFF
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END