Filename [XVS44U_09Editing.fm]
Masterpage:Left0
72
EN
Page 72 25 August 2003 10:57 am
REMOTE
Remote Control
Functions
Remote A/B/C/D Code Switching
The Remote is capable of controlling four JVC video units
independently. Each of units can respond to one of four codes
(A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
On the Remote
Keep pressing
VCR
down during steps
A
–
B
.
A
Change the remote control code.
Press the
number key “1”
for A,
“2”
for B,
“3”
for C or
“4”
for D.
B
Set the remote control code.
Press
OK
to set the code.
On the unit
C
Turn off the unit.
Press
POWER
(
1
).
D
Display the code.
Press
PLAY
(
4
) on the unit for over 5 seconds while the
unit is turned off. The code currently set appears on the
front display panel.
●
If the code displayed on the front display panel is different
from the code set on the Remote, go to step
E
.
E
Change the unit’s code.
Press
STOP
(
8
) on the Remote. The code currently set on
the Remote will be applied to the unit.
NOTE:
Once you unplug the end of the mains power cord from the
mains, the remote control code is back to A.
Before performing the following steps:
Slide the
TV/VCR/DVD
switch to the right.
XVS44U_01.book Page 72 Monday, August 25, 2003 11:08 AM
To Next Page
Loading...
Need help?
General
