EasyManuals Logo

JVC HR-XVS44U User Manual

JVC HR-XVS44U
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
Filename [XVS44U_11Trouble.fm]
Masterpage:Left+
88
EN
Page 88 25 August 2003 11:00 am
TROUBLESHOOTING (cont.)
TIMER RECORDING (VCR deck)
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. Timer recording wont work.
The clock and/or the timer have been set
incorrectly.
Re-perform the clock and/or timer
settings.
The timer is not engaged. Press
TIMER
and confirm that
#
is
displayed on the front display panel.
2. Timer programing is not possible.
Timer recording is in progress. Timer programing cant be performed
while a timer recording is in progress.
Wait until it finishes.
3.
#
on the front display panel wont
stop blinking.
The timer is engaged but theres no
cassette loaded.
Load a cassette with the record safety tab
intact.
4.
#
,
and
$
on the front
display panel wont stop blinking.
The loaded cassette has had its record
safety tab removed.
Remove the cassette and cover the hole
with adhesive tape, or insert a cassette
with the record safety tab intact.
The end of the tape was reached during
timer recording.
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
5.
#
blinks for 10 seconds and the
Timer mode is disengaged.
TIMER
has been pressed when there are
no programs in memory, or the timer
record information has been programed
incorrectly.
Check the programed data and re-
program as necessary, then press
TIMER
again.
6.
and
$
on the front display
panel wont stop blinking.
The end of the tape was reached during
Instant Timer Recording.
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
7.
N
,
and
$
on the front display
panel wont stop blinking.
The loaded cassette has had its record
safety tab removed.
Remove the cassette and cover the hole
with adhesive tape, or insert a cassette
with the record safety tab intact.
The end of the tape was reached during
Satellite Auto Recording.
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
XVS44U_01.book Page 88 Monday, August 25, 2003 11:08 AM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC HR-XVS44U and is the answer not in the manual?

JVC HR-XVS44U Specifications

General IconGeneral
BrandJVC
ModelHR-XVS44U
CategoryDVD VCR Combo
LanguageEnglish

Related product manuals