ENGLISH
47REFERENCES
Continued on the next page
Symptom Remedy/Cause
MP3/WMA/AAC
• Noise is generated. Skip to another track or change the disc. (Do not add
the extension code <.mp3>, <.wma>, or <.m4a> to
non-MP3/WMA/AAC tracks.)
• A longer readout time is required (“File Check”
keeps flashing on the display).
Do not use too many hierarchies and folders.
• Tracks do not play back in the order you have
intended them to play.
Playback order is determined when files are recorded.
• Elapsed playing time is not correct. This occurs sometimes during play. This is caused by how
the tracks are recorded on the disc.
• “Please Eject” appears on the display. Insert a disc that contains MP3/WMA/AAC tracks.
• “Not Support” appears on the display and track
skips.
Skip to the next track encoded in an appropriate format or
to the next non-copy-protected WMA track.
• Correct characters are not displayed (e.g.
album name).
This unit can only display letters (capital: A – Z,
small: a – z), numbers, and a limited number of symbols.
USB device
• Noise is generated. • The track played back is not a playable file format (MP3/
WMA/AAC/WAV). Skip to another file.track.
• Do not add the extension code <.mp3>, <.wma>,
<.m4a> or <.wav> to non-MP3/WMA/AAC/WAV
tracks.
• Tracks cannot play back as you have intended
them to play.
Playback order may differs from the one played back using
other players.
• “File Check” keeps flashing on the display. • Readout time varies depending on the USB device.
• Do not use too many hierarchy, folders and empty
folders.*
• Turn off the power then on again.
• Do not pull out or connect the USB device repeatedly
while “File Check” is displayed on the display.
* Folder that is phisically empty or folder that contains data
but does not contain valid MP3/WMA/AAC/WAV track.
• “No Files” flashes on the display.
• “No USB” appears on the display.
Connect a USB device that contains tracks encoded in an
appropriate format.
• “Not Support” appears on the display and track
skips.
The track is unplayable.
• “Read Failed” appear on the display, then
returns to the previous source.
The connected USB device may be malfunctioning, or may
not have been formatted correctly. The files included in the
USB device are corrupted.
EN44-51_KD-BT1_003A_f.indd 47EN44-51_KD-BT1_003A_f.indd 47 3/6/07 10:37:42 AM3/6/07 10:37:42 AM
To Next Page
Loading...
Need help?
General
