JVC KD-G805

10
ENGLISH
RADIO OPERATIONS
Listening to the radio
You can use either automatic searching or manual
searching to tune in to a particular station.
Searching for a station automatically:
Auto search
1 Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
* When “CLOCK DISP” is set to “CLK DISP
ON” (see page 28), the current indication will
soon change to the clock time.
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
Selected band appears*.
Lights up when receiving an FM stereo
broadcast with sufficient signal strength.
2 Start searching for a station.
When a station is received, searching stops.
To stop searching before a station is received,
press the same button you have pressed for
searching.
Searching for a station manually:
Manual search
1 Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
2 Press and hold ¢ or 4
until “M.SEEK” (manual seek)
appears on the display.
To search for stations of
higher frequencies
To search for stations of lower frequencies
FM 1
(F1)
FM 2
(F2)
FM 3
(F3)
A M
(A1)
FM 1
(F1)
FM 2
(F2)
FM 3
(F3)
A M
(A1)
EN10-12_KD-G805[U]f.p65 2/12/03, 11:42 AM10