16
ENGLISH
General settings — PSM
You can change PSM (Preferred Setting Mode) items listed in the table below and on pages 17 and 18.
4 Repeat steps 2 and 3 to adjust other PSM
items if necessary.
5 Finish the procedure.
1
2 Select a PSM item.
3 Adjust the PSM item selected.
Indications Item
( : Initial)
Selectable settings, [reference page]
DEMO
Display demonstration
• DEMO ON
• DEMO OFF
: The display demonstration will be activated automatically if no
operation is done for about 20 seconds, [5].
: Cancels.
CLOCK DISP *
1
Clock display
• CLOCK ON
• CLOCK OFF
: The clock time is shown on the display at all time when the
power is turned off.
: Cancels; pressing DISP will show the clock time for about
5 seconds when the power is turned off, [5].
CLOCK HOUR
Hour adjustment
0 – 23 (1 – 12) Initial: 0 (0:00), [5].
CLOCK MIN
Minute adjustment
00 – 59 Initial: 00 (0:00), [5].
24H/12H
Time display mode
• 24 HOUR
• 12 HOUR
: See also page 5 for setting.
CLOCK ADJ *
2
Clock adjustment
• AUTO
• OFF
: The built-in clock is automatically adjusted using the CT (clock
time) data in the RDS signal.
: Cancels.
*
1
If the power supply is not interrupted by turning off the ignition key of your car, it is recommended that you select
“CLOCK OFF” to save the car’s battery.
EN08-19_KD-PDR41_003A_7.indd 16EN08-19_KD-PDR41_003A_7.indd 16 1/8/08 9:34:41 AM1/8/08 9:34:41 AM
To Next Page
Loading...
