JVC KD-R300 User Manual

Remedies/Causes
'"" .. ,";;, ( .. , .. ' ",<' "x';>',<,,' Skip to another track or change the disc. (Do not add the
extension code <.mp3> or <.wma> to non-MP3 or
WMA tracks.)
Do not use too many hierarchical levels and folders .
. vnn,.",'»,····,·, The playback order is determined when the files are
recorded.
This sometimes occurs during playback. This is caused by
. ",'""',.".,, how the tracks are recorded on the disc.
w:!tt ....• .'-'/.. This unit can only display letters (upper case), numbers,
and a limited number of symbols.
The unit can be connected with one Bluetooth cellular
.... """ .. ,.,>". phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
?':'<';\:'.~;<;'i' from another device. Disconnect currently connected
device and search again.
• Check the Bluetooth setting of the device.
• Search from the Bluetooth device. After the device
detects the unit, select "OPEN" on the unit to connect
the device. (See page 11.)
• Enter the same PIN code for both the unit and target
device.
. • Select the device name from "SPECIAL," then try to
connect again. (See page 11.)
• Try to pair/connect from the Bluetooth device.
Adjust the microphone unit position.
• Reduce the distance between the unit and the
Bluetooth cellular phone.
• Move the car to a place where you can get a better
signal reception.
* For Bluetooth operations, refer also to the instructions supplied with the Bluetooth Adapter.
Continued on the next page
REFERENCES 31

JVC KD-R300 Specifications

General

Brand	JVC
Model	KD-R300
Category	Car Receiver
Language	English