JVC KD-SR82BT - Crossover Settings and Speaker Output; Sound Enhancement Features

ENGLISH
19
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
AUDIO SETTINGS
X ' OVER TYPE Caution : Adjust the volume before changing the X ' OVER TYPE to
avoid the sudden increase or decrease of the output level.
X ' OVER 2-WAY (Displayed only when [ X ' OVER 3-WAY ] is selected)
YES :Selects two way crossover type.; NO :Cancels.
X ' OVER 3-WAY (Displayed only when [ X ' OVER 2-WAY ] is selected)
YES :Selects three way crossover type.; NO :Cancels.
SND EFFECT
ENHANCE
(Not applicable for TUNER source.)
SML/ MED/ LRG : Virtually enhances the sound space.; OFF :Cancels.
RESPONSE LV1 / LV2 / LV3 : Virtually makes the sound more realistic.;
OFF :Cancels.
SOUND LIFT LV1 / LV2 / LV3 : Virtually adjust the sound position heard from the
speakers.;
OFF :Cancels.
VOL LINK EQ ON :Boosts the frequency to reduce the noice heard from outside the
car or running noise of the tyres.;
OFF :Cancels.
K2 (Not applicable for TUNER source and AUX source.)
ON :Improve the sound quality of compressed music.; OFF :Cancels.
Speaker output settings
(Only for X ' OVER 2-WAY )
Select the output setting for the speakers [ SPK/PRE OUT], base on the
speaker connection method.
Connection via lineout terminals
For connections through an external amplifier. (  30 )
Setting on
[ SPK/PRE OUT]
Audio signal through lineout terminal
FRONT REAR/SW
REAR/REAR Front speakers output Rear speakers output
REAR/SUB.W (default) Front speakers output Subwoofer output
SUB.W/SUB.W Front speakers output Subwoofer output
Connection via speaker leads
For connections without using an external amplifier. However, with this
settings you can also enjoy the subwoofer output.
(  30 )
Setting on
[ SPK/PRE OUT]
Audio signal through rear speaker lead
L (left) R (right)
REAR/REAR Rear speakers output Rear speakers output
REAR/SUB.W Rear speakers output Rear speakers output
SUB.W/SUB.W Subwoofer output (Mute)
If [ SUB.W/SUB.W ] is selected:
– [
FRQ 120HZ ] is selected in [ SUB.W  LPF ] and [ THROUGH ] is not available.
– [
R02 ] is selected in [ FADER ] and selectable range is [ R15 ]to [ 00 ].
JS_JVC_KD_SR82BT_K_EN_1.indd 19JS_JVC_KD_SR82BT_K_EN_1.indd 19 11/1/2016 9:03:51 AM11/1/2016 9:03:51 AM