K
Kathy WarnerSep 22, 2025
What does “PLS LOGIN” mean on JVC KD-X130 Receiver?
- MMichael Landry MDSep 22, 2025
The message “PLS LOGIN” on your JVC Receiver means that you haven’t logged in. Log in again.
To Next PageTo Next PageWhat does “PLS LOGIN” mean on JVC KD-X130 Receiver?
The message “PLS LOGIN” on your JVC Receiver means that you haven’t logged in. Log in again.
What does “DISCONNCTED” mean on JVC Receiver?
The message “DISCONNCTED” on your JVC Receiver means to check the connection to the device.
What does “NO SKIPS” mean on JVC KD-X130?
The message “NO SKIPS” on your JVC Receiver means that the skip limit has been reached. Retry later.
What does “NO STATIONS” mean on JVC Receiver?
The message “NO STATIONS” on your JVC Receiver means that no stations are found.
What does “NOT CONNCTD” mean on JVC KD-X130?
The message “NOT CONNCTD” on your JVC Receiver means that link to the application is impossible.
Why is playback order wrong on JVC KD-X130 Receiver?
If the playback order on your JVC Receiver is not as intended, note that the playback order is determined by the file name.
What to do if sound cannot be heard during playback on JVC Receiver?
If you can't hear sound during playback on your JVC Receiver, try the following: * Reconnect the Android device. * If in [AUDIO MODE], launch any media player application on the Android device and start playback. * If in [AUDIO MODE], relaunch the current media player application or use another media player application. * Restart the Android device. If the problem persists, the connected Android device may be unable to route the audio signal to the unit.
How to improve radio reception on JVC KD-X130?
To improve radio reception on your JVC Receiver, ensure the antenna is firmly connected.
How to fix JVC KD-X130 when no sound is coming out?
If you can't hear any sound, first, make sure to adjust the volume to an optimal level. If that doesn't work, check the cords and connections to ensure they are properly connected.
What to do if “MISWIRING CHECK WIRING THEN PWR ON” appears on JVC Receiver?
If you see the message “MISWIRING CHECK WIRING THEN PWR ON” on your JVC Receiver, turn the power off immediately. Check the speaker wires to ensure the terminals are properly insulated. After checking, turn the power back on.
General
