JVC KW-AVX706

ENGLISH
SETTINGS
43
Menu items Selectable settings, [reference page]
Sound
Fader/Balance
Adjust fader—speaker output balance between the front and
rear speakers.
• Upmost—front only
• Downmost—rear only
When using a two-speaker system, set the fader to the center
(00).
Adjust balance—speaker output balance between the left and
right speakers.
• Leftmost—left only
• Rightmost—right only
Volume Adjust
Adjust and store auto-adjustment volume level for each
source, comparing to the FM volume level. The volume level
will automatically increase or decrease when you change the
source.
• –12 to +12; Initial 00
Subwoofer
Adjust the settings below in the submenu:
• Phase: Subwoofer phase. Select either “Normal” or
“Reverse,” which reproduces a better sound.
• Level*
11
: Subwoofer output level. Level: –6 to +8; Initial 0
High Pass Filter Through: Select when the subwoofer is not connected.
On: Select when the subwoofer is connected.
Crossover
Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
80Hz, 120Hz, 150Hz
Amplifi er Gain You can change the maximum volume level of this receiver.
Off : Deactivates the built-in amplifier.
Low Power: VOL 00 to 30 (Select this if the maximum
power of the speakers is less than 50 W)
High Power: VOL 00 to 50
Rear Speaker*
12
You can activate/deactivate the rear speakers.
Off, On
Mode*
13
Mono
Only for FM. (Off, On), ☞ [10]
DX / Local
Only for FM. (DX, Local), ☞ [11]
SSM
Only for FM. ☞ [11]
*
11
This subwoofer level setting take effects only when surround is deactivated (
☞ also page 41).
*
12
Functions only when Dual Zone is activated.
*
13
Items listed under <Mode> vary among the playback sources.
Adjusts fader
Adjust balance
EN35-44_KW-AVX700UN_f.indd 43EN35-44_KW-AVX700UN_f.indd 43 06.2.21 9:56:27 AM06.2.21 9:56:27 AM