Need help?Do you have a question about the JVC L-F66 and is the answer not in the manual?
General| Type | Fully automatic turntable |
|---|---|
| Motor | DC servo motor |
| Signal to noise ratio | 78dB (DIN-B) |
| Effective arm length | 220 mm |
| Overhang | 15 mm |
| Tracking force adjustment range | 0-3g |
| Power consumption | 7W |
| Speeds | 33 1/3 and 45 rpm |
| Platter | 300mm Aluminum Die-cast |
| Weight | 6.5 kg |
| Tonearm type | Static Balance Type |
| Cartridge weight range | 4 to 12 g |
| Cartridge | MM Type |
| Output | 2.5mV/1kHz |
| Frequency Response | 20Hz-20kHz |
| Drive method | Belt drive |
| Signal-to-Noise Ratio | 78dB (DIN-B) |
Procedure for removing the bottom cover of the turntable unit.
Steps for removing the printed circuit board from the turntable.
Explanation of the stroboscopic pattern for RPM checking.
Function of the switch for selecting record size (17cm/30cm).
Controls for adjusting turntable platter speed (increase/decrease).
Lights indicating the turntable's current RPM.
Light indicating the record repeat play function status.
Knob to eliminate tonearm inward pull force and prevent stylus wear.
Lever used to lower or lift the tonearm.
Button to initiate record play, automatically detecting record size.
Button to stop record play halfway.
Button to enable or disable automatic repeated playback.
Switch to change turntable RPM between 33 1/3 and 45.
Exploded view of the turntable and cabinet assembly components.
Exploded view of the turntable mechanism assembly parts.
Exploded view of the tonearm assembly components.
Procedure to adjust tonearm height for proper stylus positioning.
Adjusting the tonearm's automatic lead-in position on the record.
Adjusting the tonearm's automatic lead-out point based on audio signal or groove.
Diagnostic steps for when the turntable fails to rotate.
Troubleshooting steps for excessive turntable rotation speed.
Diagnosing why the tonearm fails to return to its rest position.
Troubleshooting steps for the REJECT function not working.
Steps to diagnose why the turntable won't start.
To Next Page
