10
Setting up your TV
Connecting the power cord to
the AC outlet
Insert the AC plug on the power cord from
the TV into an AC outlet. The TV will enter
standby mode.
Caution
• Operate only from the power source
specified (AC 220 – 240 V, 50/60 Hz) on
the unit.
• Remove the AC plug from the outlet to
completely disconnect the TV from the
power supply.
Putting the batteries into the
remote control
Use two AA/R6 dry cell batteries.
Insert the batteries from the - end, making
sure the + and - polarities are correct.
• Follow the warnings printed on the
batteries.
• Battery life is about six months to one
year, depending on how much you use the
remote control.
• The batteries supplied are only for setting
up and testing your TV, please replace
them as soon as you need to.
• If the remote control does not work
properly, replace the batteries.
Initial settings
When the TV is first turned on, it goes into
the initial settings mode and the Quick Setup
menu will appear. Follow the instructions on
the screen display to make the initial settings.
1 Make sure to set the VCR/TV/DVD
switch on the remote control to the
TV position
• You cannot turn the TV on when the
VCR/TV/DVD switch is set to the
VCR or DVD position.
2 Press the (Standby) button on
the remote control
The TV turns on from standby mode and
the Quick Setup menu is displayed.
• Check that the AC plug on the power
cord from the TV is connected to AC
outlet.
MENU button
7 /OK
buttons
button
VCR/TV/DVD
switch
Remote control
sensor
Power lamp
To Next Page
Loading...
