13
Quick Setup Getting Started
Remove the terminal cover
There are connection terminals behind the covers on the left and right in the back of the TV.
Remove these two covers before connecting an antenna or other devices. The covers can
be removed by removing the hooks. When replacing the covers, place the side of the covers
against the TV and insert the hooks.
Note:
• Leave the terminal covers off if they do not fit properly. Do not force to replace the covers.
Doing so may damage the connection cables and covers.
Cable Holder
A cable holder which keeps your connection cables tidy is attached on the back of the stand.
Gently squeeze the left and right of the cable holder, and pull it to remove it from the stand.
After putting the cables in the cable holder, attach it to the back of the stand again.
Cable Holder
Illustration of LT-32X776 and LT-26X776
Illustration of LT-37X776 and LT-40X776
Illustration of
LT-32X776 and LT-26X776
Illustration of
LT-37X776 and LT-40X776
LCT1881-001B-A ENG e 13 5/20/05, 4:29:11 PM
To Next Page
Loading...
Need help?
General
