23
Quick Setup Connections
Connecting to an amplifier using your optical output
You can connect an amplifier that has an optical digital input terminal by using an optical digital
cable from the optical output. The signal that is output can be PCM or Dolby Digital.
i.LINK
IN/OUT
S400(TS)
OPTICA
L
OUT
Digital Audio
Television Rear Panel
Amplifier
1) Connect the optical cable from underneath the television to the back of the amplifier.
Notes:
• This terminal can only output digital audio.
• In order to use the optical output connection, select PCM or Dolby Digital on Digital Sound in
the Digital Setup Menu. See page 71.
• Refer to your owners manual on using your amplifier.
LCT1881-001B-A ENG e 23 5/20/05, 4:29:14 PM
To Next Page
Loading...
Need help?
General
